Menu
Bosch Multicom BMC-3G Installation And Operation Manual
  |
Multicom BMC-3G GPRS Modulewith Solution 2000 & 3000There are 14 steps in this Multicom BMC-3GInstallation Guide. Please ensure you completeeach step in order.The Multicom BMC-3G module is designed to provide GPRS Base Station reporting.It connects directly to the panel on the SDI-2 Bus.There are 14 steps that an Installer will need to follow to set up the panel and the GPRS unit.The following is from the Multicom BMC-3G Installation Guide.An overview of the basic hardware installationsteps. The full Multicom manual is available---> bitly/mc3gman1 Mount the PanelThe BMC-3G fits into any standard alarmpanel housing.Mounting orplacement inside theexisting alarm panelhousing requires theprovided fly lead tobe attached and theincluded antenna tobe mounted to thetop of the panel.Note: If the BMC-3G is being installed in a poorsignal area, please consider using a high-gainantenna available from your Multicom supplier.BMC-3G(Steps 1-3)AlarmLINK(Steps 4-6)TechTools(Steps 7-14)!Connectthe BMC-3Gcommunicator toyour Bosch alarmpanel.Setup arm/disarmto give customerscontrol of theMulticom via theAlarmLINK app.Install TechToolsand program theMulticom. Addrelays and techs.Use TechTools toadd customers toAlarmLINK andyour logo.2 Connect to the Bosch PanelThe BMC-3G connects directly to the Boschpanel as shown in the following wiring diagram.If the 12V auxiliary power output is unable tosupply the required 200mA, connect to a fixed12V DC power supply (>200mA).Note that TOTAL CURRENT DRAW on theSDI-2 bus is 900mA MAX includingCodepads and existing SDI-2 modules.Introduction Connect the Multicom BMC-3G |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved