Bosch KGF39SM30/19 Manual

Also see for 8 Series: Instruction manual Recipes Instruction manual Installation instructions Assembly instructions

en38Removing the containerFig. ,Pull out the container all the way and liftto detach it.To insert the container, place onthe telescopic rails and push intothe appliance. Attach the container bypressing it down.Taking out the humidity filterFig. !/16The humidity filter over the humiditycontainer can be taken out for cleaning.To do this, first take out the humiditycontainer and pull out the humidity filter.Lift off the filter cover, Fig. -, and takeout the filter. Clean in lukewarm water,leave to dry and re-assemble.Taking out the frozen food containerFig. $Pull out the frozen food container allthe way, lift at the front and remove.General information for lookingafter the surfacesClean surfaces with luke warm waterand a little washing-up liquid. Aftercleaning, rub thoroughly dry.Light (LED)Your appliance features a maintenance-free LED light.These lights may be repairedby customer service or authorisedtechnicians only.Tips for saving energy■ Install the appliance in a dry, wellventilated room! The appliance shouldnot be installed in direct sunlightor near a heat source (e.g. radiator,cooker).If required, use an insulating plate.■ Allow warm food and drinks to cooldown before placing in the appliance.■ Thaw frozen food in the refrigeratorcompartment and use the lowtemperature of the frozen food to coolrefrigerated food.■ Open the appliance as briefly aspossible.■ To avoid increased powerconsumption, occasionally clean theback of the appliance.■ If available:Fit wall spacers to obtain the indicatedenergy rating of the appliance (seeInstallation instructions). A reducedwall gap will not restrict the functionof the appliance. The energy ratingmay then increase slightly. The gapof 75 mm must not be exceeded.■ The arrangement of the fittings doesnot affect the energy rating of theappliance.