Bosch HMD8451UC Installation Instructions Manual

Also see for 800 Series: Installation instructions Service manual Quick start and safety guide Use and care manual Installation manual

Contents

English 7Electrical RequirementsThe unit requires a 120 volt, 60 Hz, 15 AMP (minimum) circuit. It is recom-mended that the unit be installed on a separate circuit that serves only thisappliance.This appliance is fitted with a 3-prong grounded electrical plug. Do not modifythe plug or use an adapter. If the plug does not fit with the available recep-tacle, have a licensed electrician install a properly grounded outlet beforeproceeding with the installation. The power cord length is approximately 46".Installer - show the owner the location of the circuit breaker or fuse. Mark it foreasy reference.Note: If you have any questions about the grounding or electrical instructions,consult a qualified electrician or service person.* Can also be installed using an electrical outlet in an adjacent cabinet within the area where the provided electrical cord can reach.Always check electrical codes for requirements.Drawer Installation1. Place the drawer adjacent to the wall or cabinetopening. Plug the power supply cord into theelectrical outlet.2. Carefully guide the drawer into the prepared open-ing. Avoid pinching the cord between the oven andthe wall.3. Slide the drawer all the way until the mountingflange makes contact with the face of the cabinetfor standard installation or side cleats for flushinstallation. See Figure 7A.4. Open the drawer. Using the 4 holes on the draweras a template, pre drill the cabinet using a 1/16 " bit.See Figure 7A.5. Secure the drawer with the 4 screws supplied. SeeFigure 7B.6. Test operation to confirm that the Drawer Micro-wave is functioning properly and the drawer opensand closes freely.Figure 64"5"Suggested electricaloutlet location*4 ScrewsParts suppliedFigure 7BMountingflangeFigure 7ACleat