To remove the oven door:, Be sure to read theabove WARNINGbefore attempting toremove the door.2. Open the doorcompletely.3. Flip levers on hingestoward you., Holding the door firmlyon both sides andusing both hands,close the door gentlyuntil it stops againstthe levers, about 30 °from the closedposition.5. Carefully lift the doorup and out of thehinge slots. Holdfirmly; the door isheavy.6. Place the door in aconvenient and stablelocation unitl you areready to reinstall it.Placing the Oven Into the CabinetOpening1. The unit and its bottom packaging (pallet) should bepositioned close to and in front of the cabinet openingprior to beginning to lift the unit into place.CAUTIONTo avoid damage to the door do not lift, pull or pushthe unit during installation by using the oven doorhandle as a gripping point.Note: It is recommended to wear gloves and long sleevesto protect hands and forearms from abrasion andpotential scratches during the lifting process. It isalso recommended to take off watches and jewelryand to wear work shoes during installation for footprotection.When lifting the unit into place avoid grasping the upperelement to avoid damaging it. See the illustration followingfor the correct lifting point.,3.Lift or slide unit into the cabinet cutout without allowingthe unit base to contact the flooring.Check that the conduit cable does not fall behind theunit during installation. It may help to run the conduitinto the area it will be connected to (such as anoverhead or adjacent cabinet) and tape the end downso it doesn't fall out while the unit is being slid intoplace.English 9