Bosch GSC 10,8 V-LI Professional Original Instructions Manual

Also see for 8 V-LI Professional: Original instructions Original instructions Original instructions Original instruction manual Original instructions

English | 15Bosch Power Tools 1 609 929 S25 | (11.12.08)f When the battery is defective, liquid can es-cape and come into contact with adjacentcomponents. Check any parts concerned.Clean such parts or replace them, if required.f Use the battery only in conjunction with yourBosch power tool. This measure alone pro-tects the battery against dangerous overload.Functional DescriptionRead all safety warnings and allinstructions. Failure to follow thewarnings and instructions mayresult in electric shock, fire and/orserious injury.While reading the operating instructions, unfoldthe graphics page for the machine and leave itopen.Intended UseThe power tool is intended for cutting sheetmetals without loss due to metal chips. It is suit-able for curved and straight cuts.Product FeaturesThe numbering of the product features refers tothe illustration of the machine on the graphicspage.1 Battery unlocking button2 Battery3 Button for charge-control indicator4 Battery charge-control indicator5 On/Off switch6 Chip deflector7 Allen key8 Fastening screw for upper cutter9 Upper cutter10 Bottom cutter11 Adjustment screw, bottom cutter12 Fastening screw for bottom cutter13 Setting gauge**Accessories shown or described are not part of thestandard delivery scope of the product. A completeoverview of accessories can be found in our acces-sories program.Technical DataNoise/Vibration InformationMeasured values determined according toEN 60745.Typically the A-weighted sound pressure level ofthe product is less than 70 dB(A). UncertaintyK < 1.5 dB.The noise level when working can exceed80 dB(A).Wear hearing protection!Vibration total values (triax vector sum) deter-mined according to EN 60745:Vibration emission value ah = 3.5 m/s 2 ,Uncertainty K < 1.5 m/s 2 .The vibration emission level given in this infor-mation sheet has been measured in accordancewith a standardised test given in EN 60745 andmay be used to compare one tool with another.It may be used for a preliminary assessment ofexposure.The declared vibration emission level repre-sents the main applications of the tool. Howeverif the tool is used for different applications, withdifferent accessories or poorly maintained, thevibration emission may differ. This may signifi-cantly increase the exposure level over the totalworking period.Cordless Sheet MetalShearsGSC 10,8 V-LIProfessionalArticle number 3 601 J26 1..Rated voltage V= 10.8Stroke rate at no load n0 min-1 3600Max. steel sheet cut-ting capacity* mm 1.3Smallest curve radius mm 15Weight according toEPTA-Procedure01/2003 kg 1.4* to 400 N/mm2 with reference to steel sheetPlease observe the article number on the type plateof your machine. The trade names of the individualmachines may vary.OBJ_BUCH-840-002.book Page 15 Thursday, December 11, 2008 4:11 PM