215. CAMERA RE-ASSEMBLYMake sure all wires are properly connected andtightened into the terminal blocks, all holes aresealed against moisture penetration, and allmounting screws are tight.Step 5.1 - Check that the large “O” ring gasketin the camera base has not beendislodged or distorted.Step 5.2 - Gently press the camera dome inplace. Move the retaining ring overthe dome.Step 5.3 - Use the protruding set-screws in theretaining ring to carefully rotate thering clockwise until it is slightly snug,but not so tight that the ring cannotrotate further.Step 5.4 - Press firmly on the dome and rotatethe retaining ring until one of theset-screws aligns with theadhesive dot on the side of thedome. Tighten all set-screws withthe supplied Allen key.Refer to Figure 5-1 on page 22.

Bosch EX40N Installation Instructions Manual

installation instructions

Description

Unpacking

Initial Preparations

Section 1. Dome Removal

Section 2. Input Power Connections

Section 3. Mounting - Camera Base

Section 4. Adjustments

Section 5. Camera Re-Assembly

Section 6. Troubleshooting Guide

Section 7. Template – Mounting Holes

Section 8. General Specifications

EX40N

Bosch EX40N Installation Instructions Manual

Product

Learn More

Legal