Bosch DWB97CM50B/03 Instructions For Installation And Use Manual

Also see for 6 Series: Instruction manual User manual Instruction manual Instructions for installation and use Instructions for installation and use

Important safety information en5:Warning – Risk of burns!■ The accessible parts become very hot whenin operation. Never touch hot parts. Keepchildren at a safe distance.Risk of burns!■ The appliance becomes hot duringoperation. Allow the appliance to cool downbefore cleaning.:Warning – Risk of injury!■ Components inside the appliance may havesharp edges. Wear protective gloves.Risk of injury!■ Items placed on the appliance may falldown. Do not place any objects on theappliance.Risk of injury!■ The light emitted by LED lights is verydazzling, and can damage the eyes (riskgroup 1). Do not look directly into theswitched on LED lights for longer than 100seconds.:Warning – Risk of electric shock!■ A defective appliance may cause electricshock. Never switch on a defectiveappliance. Unplug the appliance from themains or switch off the circuit breaker in thefuse box. Contact the after-sales service.Risk of electric shock!■ Incorrect repairs are dangerous. Repairsmay only be carried out and damagedpower cables replaced by one of ourtrained after-sales technicians. If theappliance is defective, unplug the appliancefrom the mains or switch off the circuitbreaker in the fuse box. Contact the after-sales service.Risk of electric shock!■ Do not use any high-pressure cleaners orsteam cleaners, which can result in anelectric shock.Risk of electric shock!■ Penetrating moisture may result in anelectric shock. Clean the appliance using adamp cloth only. Before cleaning, pull outthe mains plug or switch off the circuitbreaker in the fuse box.Causes of damageCaution!Risk of damage due to corrosion. Alwaysswitch on the appliance while cooking to avoidcondensation. Condensate can producecorrosion damage.Always replace faulty bulbs to prevent theremaining bulbs from overloading.Risk of damage due to ingress of humidity intothe electronic circuitry. Never clean operatorcontrols with a wet cloth.Surface damage due to incorrect cleaning.Clean stainless steel surfaces in the directionof the grain only. Do not use any stainlesssteel cleaners for operator controls.Surface damage due to strong or abrasivecleaning agents. Never use strong andabrasive cleaning agents.Risk of damage from returning condensate.Install the exhaust duct in such a way that itfalls away from the appliance slightly (1°slope).Risk of damage as a result of incorrectloading of design elements. Do not pull designelements.Do not place objects on the designelements or hang objects from them.Caution!There is a risk of surface damage if you do notpeel off the protective film.Remove theprotective film from all parts of the appliancebefore using the appliance for the first time.