Bosch BUTCHERS & BICYCLES MK1-E eBIKE SYSTEM Generation 3 Original Instructions Manual

Also see for 0 275 007 510: Original instructions Instructions Original instructions Original instructions Instructions

Page 33English–30 275 007 XCX | (19.4.17) Bosch eBike SystemsThe charging state is displayed by the battery charge-controlindicator 9 on the battery and by the bars on the on-boardcomputer.During the charging procedure, the LEDs of charge-controlindicator 9 on the battery pack light up. Each continuously litLED is equivalent to a charge capacity of approx. 20 %. Theflashing LED indicates the charging of the next 20 %.Once the eBike battery is fully charged, the LEDs extinguishimmediately and the on-board computer is switched off. Thecharging procedure is terminated. The charging state can bedisplayed for 3 seconds by pressing the on/off button 10 onthe eBike battery.Disconnect the charger from the main power supply and thebattery pack from the charger.When disconnecting the battery pack from the charger, thebattery pack is automatically switched off.Note: If you have charged on the bike, carefully close thecharge socket 6 with the cover 7 after the charging procedureso that no dirt or water can get in.If the charger is not disconnected from the battery aftercharging, after a few hours the charger will switch itself backon, check the charging state of the battery and begin thecharging procedure again if necessary.Troubleshooting – Causes and CorrectiveMeasuresMaintenance and ServiceMaintenance and CleaningIf the charger should fail, please refer to an authorised bicycledealer.After-sales Service and Application ServiceIn case of questions concerning the charger, please refer to anauthorised bicycle dealer.For contact data of authorised Bosch eBike dealers, pleaserefer to www.bosch-ebike.comDisposalBattery chargers, accessories and packaging should besorted for environmental-friendly recycling.Do not dispose of battery chargers into household waste!Only for EC countries:According to the European Directive2012/19/EU on waste electrical and electronicequipment and its transposition into nationallaw, chargers that are no longer usable must becollected separately and sorted for environmen-tal-friendly recycling.Subject to change without notice.Cause Corrective MeasureTwo LEDs of the batterypack flashingBattery pack defective Refer to an authorised bicycledealer.Three LEDs of the batterypack flashingBattery pack too warm or toocoldDisconnect the battery fromthe charger until the chargingtemperature range has beenreached.Do not connect the batterypack to the charger until it hasreached the allowablecharging temperature.No LEDs flashing (one ormore LEDs will remainpermanently lit dependingof the state of charge of theeBike battery).The charger is not charging. Refer to an authorised bicycledealer.No charging procedure possible (no indication on batterypack)Plug not inserted correctly Check all plug connections.Contacts of battery packsoiledCarefully clean the contactsof the battery pack.Socket outlet, cable orcharger defectiveCheck mains voltage, havecharger checked throughbicycle dealerBattery pack defective Refer to an authorised bicycledealer.Cause Corrective Measure