9001663217 (020401) SGS2ITW08G*9001663217* Quick reference guide Dishwasheren Before using for the first time, read the instruction manual and the safety information it contains.Short and handy...... everything your dishwasher needs.Overview of water hardness settingsYou can find an overview of the water hardness values that can beselected here.A table of country-specific units can be found in the instructionmanual.Hardnessrangemmol/l Level LED A LED B LED CSoft 0 - 1.1 0Medium 1.2 - 2.9 1Hard 3.0 - 3.7 2Hard 3.8 - 6.2 3Setting the water softening sys-tem1. Press .2. To open the appliance settings,press for 3 seconds.a is flashing on the display.3. Press repeatedly until the rightwater hardness has been set.0, 1, 2 or 3 LEDs will light up ac-cordingly.4. To save the settings, pressfor 3 seconds.Adding special saltTo avoid damage to the appliance, only add specialsalt to the dispenser for special salt just before theprogramme starts.1. Unscrew the lid of the dispenser for special saltand remove.2. On initial start-up: Fill the dispenser right up withwater.3. Add the special salt to thedispenser. The water in thedispenser is displaced andforced out. Never add de-tergent.4. Place the lid back on the dispenser and turn toclose.Adding rinse aid1. Press the catch on the lidof the dispenser for rinseaid and lift .122. Add rinse aid up to themax mark.max3. Close the lid of the dispenser for rinse aid.a The lid clicks into position.How to use your appliance1. Load the tableware.Only clean tableware that is suitable for dish-washers. Remove large remnants of food fromthe tableware. Check that the spray arms can ro-tate freely.2. Add detergent.3. Switch on the appliance .4. Select the programme.5. Start the programme .6. Remove the tableware at the end of the pro-gramme.7. To cancel the programme, press forapprox. 4 seconds.The programme is cancelled and ends after ap-prox. 1 minute.ProgrammesThe programme data has been meas-ured in the laboratory according toEuropean standard EN 60436.The consumption figures depend onthe programme and additional func-tion selected.The runtime will change if the rinseaid system is switched off or rinse aidneeds to be added.Programme 1) Duration [h:min]2) Energy [kWh]3) Water [l]Intensive 70°1) 2:10 - 2:152) 1,300 - 1,3503) 11,0 - 13,5Auto 45-65°1) 1:45 - 2:452) 0,850 - 1,3503) 9,5 - 15,5Eco 50°1) 4:302) 0,9233) 10,5Express 65° - 1h1) 1:002) 1,1003) 10,0Machine Care1) 2:102) 1,4503) 15,0Adding detergent1. Add the detergent to thedry detergent dispenser.15 ml25 ml50 ml2. Close the lid of the deter-gent dispenser.a The lid clicks into position.