Menu
Black & Decker Smart Scan AD925 Instruction Manual
                                            |
9• Remove batteries if the device will not be used for several months.“Transporting batteries can possibly cause fires if the battery terminals inadvertentlycome in contact with conductive materials such as keys, coins, hand tools and thelike. The US Department of Transportation Hazardous Material Regulations (HMR)actually prohibit transporting batteries in commerce or on airplanes (i.e. packed insuitcases and carry on luggage) UNLESS they are properly protected from shortcircuits. So when transporting individual batteries, make sure that the batteryterminals are protected and well insulated from materials that could contact them andcause a short circuit.”To operate the Tool on Battery Power:1. Disconnect the Tool from the vehicle.Unplug the OBD II Connector from the vehicle’s DLC.2. Turn On the Power.• Press and hold down the Power On/Off key.• The Tool warms up and displays the most recently retrieved Trouble Codes.3. Review the data:READ/Scroll Down key or theERASE/Scroll Up key.The Tool has a backlit LCD. When using the Tool under battery power:4.Power Down the Tool.When you are done reviewing the diagnostic codes, press and hold the Power On/Offkey to turn off the Tool.The Tool will store the findings in the Tool’s internal memory until the next time youconnect to a vehicle.If you plug the Tool back into a vehicle, the Tool will update the diagnostic codes storedin the Tool’s internal memory with the latest diagnostic codes from the vehicle’scomputer modules.Because some problems must be present over time before a code is reported, you mayget slightly different results.What Are Diagnostic Trouble CodesDiagnostic Trouble Codes (DTCs) are used to determine what is wrong with a vehicle.Some DTCs are defined by the Society of Automotive Engineers (SAE). DTCs notassigned or reserved by the SAE are reserved for the vehicle manufacturer. Thesecodes are referred to as Manufacturer Specific Codes.Key Presses Display ResponseNo key press in a 1-minute period Tool turns off LCD backlighting to conservebattery power.No key presses after 2 minutes Tool will power off.Key pressed prior to the Tool LCD backlight turns back on.powering offNOTE: |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved