Black & Decker Price Pfister Brookwood 34 Series Manual

ENGLISHENGLISH87 9109 SECURING FOUR HOLE FAUCET TO DECKFrom underneath sink, hand tighten Wing Nuts (9A) to Mounting Posts (9C). Removeany excess putty from around the outside edge of Deck Plate (9B). From underneathsink, secure the faucet by placing the Metal Washer (9D) and the Long Nut (7/16 Hex.)(9E) onto the Mounting Post (9F). Make sure that the bumps on the Metal Washer (9D) arefacing up. Tighten using a flat head screwdriver or an adjustable wrench until the faucet isfirmly connected to the sink. Do not over tighten!10 HOSE GUIDE INSTALLATIONInsert Hose Guide Shank (10A) through Flange Gasket (10B) and into the sink hole.From underneath sink, secure Hose Guide (10A) by screwing Plastic Locknuts (10C).Hand tighten.Caution: do not over tighten!7 SECURING THREE HOLE FAUCET TO DECKFrom underneath sink, secure the Hose Guide (7A) by screwing the Plastic Locknut(7B). Secure Deck Plate (7C) by screwing Wing Nut (7D) to Mounting Post (7E). Handtighten. Remove any excess putty from around the outside edge of Deck Plate (7C).Secure faucet by placing the Metal Washer (7F) and the Long Nut ( 7/16 Hex.) (7G) ontoMounting Post (7H). Make sure that the bumps on the Metal Washer (7F) are facing up.Tighten until the faucet is firmly connected to the sink. Do not over tighten!8 FOUR HOLE FAUCET INSTALLATIONFollowing manufacturer’s recommendations on use, apply plumber’s putty into puttygroove in Bottom Plate (8A). Insert the faucet Supply Tubes (8B) through the centerhole of the sink. Insert faucet Shanks (8C) through the end holes of the sink.STOP Go To Step 1138A8C8B9A9A 9C9C9B9D9E10A10B10C9F7A7C7B7G7H7F7D7E