874. Plug in the unit into an electrical outlet.5. Press the On/Off (I/0) switch (S).6. Remove the steam nozzle from its holder facing upward, awayfrom you and press the Steam button (T). The indicator lightson the unit illuminate and in a few seconds steam is released.Important:• Never place your hand in front of steam nozzle where steamis being released.• Do not leave the steam nozzle in one area for a long period oftime because the garment will get wet.7. Use the lint brush to remove lint from the fabric as it steams.Automatic ShutoffThe unit shuts off automatically:• After 30 minutes of inactivity• If water tank is emptyTo use the unit again, turn Off then On and resume operation.Care and CleaningThis product contains no user serviceable parts. Refer service to qualified servicepersonnel.Cleaning1. Make sure the unit is off.2. Wait for the unit to cool down completely before draining the water tank.3. Remove water tank and drain any remaining water.4. Wipe the outside surface with a damp cloth. Never immerse the unit in wateror other liquids.Storage• Make sure unit is off and unplugged.• Unit stores vertically for compact storage. If you need more height, you canadjust the extension tubes.• Insert the steam nozzle in its holder and wrap the cord around the cord wrap.Important: If you want to leave your unit ready for daily use, just leave the watertank filled and in place.STPROBLEM CAUSE SOLUTIONSteamer Does 1. Steamer is not plugged 1. Plug power cord intoNot Get Hot into electrical outlet. electrical outlet.2. Flexible hose is not 2. Check flexible hoseconnected properly. connection.3. Unit shuts off 3. Turn off unit thenautomatically. on again.No Steam Water level is too low. Refill the water tankfollowing instructionson page 6Water Drips Condensation has formed Hold the steamer hoseFrom The inside the steamer hose. upright fully extended andSteam Nozzle allow excess moisture todrain back in the waterreservoir.TROUBLESHOOTINGGSR10Pub1000002369 6/14/05 4:57 PM Page 8