Black & Decker GH900 Manual

Also see for gH900: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

REWINDING SPOOL FROM BULK LINE(USE ONLY .065 IN. ROUND DIAMETER LINE)Bulk line is also available for purchase from your local retailer. NOTE: Hand wound spoolsfrom bulk line are likely to become tangled more frequently than Black+Decker factorywound spools. For best results, factory wound spools are recommended.To install bulk line, follow the steps below:• Unplug trimmer.• Remove the empty spool from the trimmer as described in "REPLACING THE SPOOL".• Remove any remaining cutting line from the spool.• Make a fold at the end of the cutting line at about 3/4 inch (19mm)(21). Feed the cuttingline into one of the line anchoring slots (22) as shown in figure O.• Insert the 3/4 inch (19mm) end of the bulk line into the hole (23) in the spool adjacent to theslot as shown in figure P. Make sure the line is pulled tight against the spool as shown infigure P.• Wind the cutting line onto the spool in the direction of the arrow on the spool. Make sure towind the line on neatly and in layers. Do not crisscross (figure Q).• When the wound cutting line reaches the recesses (24), cut the line. (figure P).• Fit the spool onto the trimmer as described in "REPLACING THE SPOOL".ACAUTION: Beforeyou begintrimming,onlyusetheappropriatetypeofcuttingline.AUTOMATIC LINE FEED DOES NOT WORK• Unplug the trimmer.• Remove the spool cap.• Pull the cutting line until it protrudes approximately 5-3/8 inches (136mm) from the spool. Ifinsufficient cutting line is left on the spool, install a new spool of cutting line.• Ensure that the line is not crisscrossed on the spool as detailed in figure Q. If it is, unwindthe cutting line, then wind it back on the spool neatly so that the lines do not cross.• Ensure the beginning of the cutting line is pulled tight against the spool as shown in figure P.• Align the tabs on the spool cap with the cut outs in the housing.• Push the spool cap onto the housing until it snaps securely into place.• If the cutting line protrudes beyond the trimming blade, cut it off so that it just reaches the blade. Ifthe automatic line feed still does not work or the spool is jammed, try the following suggestions:• Carefully clean the spool and housing.• Remove the spool and check if the lever in the spool housing can move freely.• Remove the spool and unwind the cutting line, then wind it on neatly again. Aeplace thespool into the housing.

/ 5

Related manuals for Black & Decker gH900