Menu
Black & Decker BDS200 Manual
                                            |
3ENGLISHIntended useThis Black & Decker tool has been designed to aid in locatinglive wires operating at mains voltage (230 V AC) and metalpipes behind internal walls. This tool is intended for consumeruse only.Safety instructions Warning! When using battery-powered tools, basic safetyprecautions, including the following, should always befollowed to reduce the risk of fire, leaking batteries,personal injury and material damage. Read all of this manual carefully before operating the tool. Retain this manual for future reference.Keep work area cleanCluttered areas and benches can cause accidents.Consider work area environmentDo not expose the tool to rain. Do not use the tool in damp orwet conditions. Keep the work area well lit. Do not use thetool where there is a risk of causing fire or explosion, e.g. inthe presence of flammable liquids and gases.Keep children awayDo not allow children, visitors or animals to come near thework area or to touch the tool.Do not overreachKeep proper footing and balance at all times.Stay alertWatch what you are doing. Use common sense.Do not operate the tool when you are tired.Use appropriate toolThe intended use is described in this instruction manual.Warning! The use of any accessory or attachment orperformance of any operation with this tool other than thoserecommended in this instruction manual may present a risk ofpersonal injury.Check for damaged partsBefore use, carefully check the tool for damage. Ensure thatthe tool will operate properly and perform its intended function.Do not use the tool if any part is damaged or defective.Store idle toolsWhen not in use, tools and batteries should be stored in a dry,locked up or high place, out of reach of children.RepairsThis tool complies with relevant safety requirements.Repairs should only be carried out by qualified persons usingoriginal spare parts; otherwise this may result in considerabledanger to the user.Additional safety instructions for non-rechargeablebatteries Never attempt to open for any reason. Do not store in locations where the temperature mayexceed 40 °C. When disposing of batteries, follow the instructions givenin the section "Protecting the environment". Do notincinerate the batteries. Under extreme conditions, battery leakage may occur.When you notice liquid on the batteries, proceed asfollows:- Carefully wipe the liquid off using a cloth.Avoid skin contact.Additional safety instructions for pipe and wiredetectors Do not use the tool to detect AC voltage in uninsulated,exposed or free wires. Do not use the tool as a substitute for a voltmeter. Be aware that the tool may not always properly detect allpipes and wires. The following conditions can causeinaccurate results:- Low battery- Thick walls with thin pipes or wires- Very thick walls- Very deep wires or pipes- Walls covered with metal- Very humid conditions- Shielded cables Before use, always test the tool by detecting a known pipeor wire. If in doubt contact a qualified contractor.Warning! This tool will not detect wires in circuits isolatedfrom the mains supply, cables operating at direct current (DC)or wires used for telecommunication or computer systems.Hidden wires (e.g. wall lights) may not be detected whenswitches are in the off position.Warning! This tool will not detect pipes of any other materialthan metal.Features1. Mode selector switch2. LED indicator3. Sensitivity dialFig. A4. Battery coverAssemblyFitting the battery (fig. B) Slide the battery cover (4) off the tool. Connect the battery to the connector. The larger batteryterminal connects to the smaller connector terminal. |
Related manuals for Black & Decker BDS200
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved