Black & Decker BDH1850SM Instruction Manual

Also see for BDH1850SM: Instruction manual

Contents

9• Press the ON/OFF button (1). It takes approximately 15 seconds for the steam mop to heat up.• Press the SmartSelectTM button (2) until the required setting is reached.• Pulling the handle tube back will activate the steam pump. After a few seconds steamwill start to come out of the steam head.NOTICe: If the system has been run dry it may take up to 30 seconds to prime thesystem on first use.• It takes a few seconds for steam to enter the cleaning pad. The steam mop will nowglide easily over the surface to be sanitized/cleaned.• Push and pull the steam mop slowly across the floor to thoroughly steam clean each section.NOTICe: During use you may turn off the steam pump by returning the handle tothe upright position, this convenient feature will allow you to place the steam mop onthe resting mat for a short time so that you may move items or furniture, then continuecleaning without the need to switch the appliance off.• When you have finished using the steam mop, return the handle tube to the uprightposition and turn it ‘OFF’, place it on the resting mat and wait until the steam mop coolsdown. (approximately five minutes)hAND heLD STeAM CLeANINg - fig ONOTICe: To effectively sanitize an area, the lift and reachhead with microfiber pad must be used.• Remove the hand held steam cleaner (3) from thesteam mop body (10).• Attach the required accessory.• Plug hand held steam cleaner electric cord into the outlet.• Press the ON/OFF button (1). It takesapproximately 15 seconds for the hand held steamcleaner to heat up.• Lift the lock off (24) and pull the trigger switch (25)to activate the steam pump. After a few secondssteam will start to come out of the accessory.NOTICe: During use you may turn off the steam pump by releasing the trigger switch,this convenient feature will allow you to place the hand held steam cleaner down for ashort time so that you may move items or furniture, then continue cleaning without theneed to switch the appliance off.• When you have finished using the hand held steam cleaner, release the triggerswitch and turn it ‘OFF’, wait until the steam cleaner cools down before storing.(approximately five minutes)CARPeT RefReShINgCAUTION: It is important to monitor the water level in the water tank. To refill thewater tank and continue to sanitize/ clean, return the handle tube (4) to the upright positionand turn the steam mop ‘OFF’. Unplug the unit from the wall outlet, and refill the water tankwith supplied water jug.CAUTION: Never leave the steam mop in one spot on any surface for any periodof time. Always place the steam mop on the resting mat (7) with the handle tube in the uprightposition when stationary and make sure the steam mop is turned off when not in use.• Place the carpet glider (8) on the floor.• Lightly press the steam mop down onto the carpet glider until it clicks into place.• Place the steam mop on the resting mat.• Plug the steam mop electric cord into the outlet.• Press the ON/OFF button (1). It takes approximately 15 seconds for the steam mop to heat up.• Press the SmartSelectTM button (2) to the Wood/Laminate setting.• Pulling the handle tube back will activate the steam pump. After a few seconds steamwill start to come out of the steam head.• Push and pull the steam mop slowly across the carpet to thoroughly refresh each section.NOTICe: During use you may turn off the steam pump by returning the handle tube to theupright position, this convenient feature will allow you to place the steam mop on the restingmat so that you may move items of furniture with out the need to switch the appliance off.• When you have finished using the steam mop, return the handle tube to the uprightposition and turn it ‘OFF’, place it on the resting mat and wait until the steam mop coolsdown. (approximately five minutes)25241O