Black & Decker BCFK356 Instruction Manual

Also see for BCFK35: Instruction manual

Page 7INSTALLATION GUIDE1. Unpack your freezer by removing all packaging materials like carton, base, foams,adhesive tape, etc.2. Remove all accessories, internal packaging material used to hold shelves, ice tray,etc. in place.3. Clean the remains of all adhesive tape used and remove all printed materialsupplied.4. Install the freezer in a convenient location away from extreme heat and cold. Allowsufficient clearance between the freezer and side wall so the door(s) will openwithout obstruction. Freezer is not designed for recessed installation.5. The floor on which the freezer should be placed must be flat, hard, solid, andeven. The freezer should not be placed on any soft material such as foam, plastic,carpeting, etc.6. The following are recommended minimum clearances around the freezer forproper air circulation:Sides: 3/4” (19mm)Back: 2” (50mm)Proper air circulation will help your freezer work at maximum efficiency.NOTE: The appliance must be correctly connected to the power supply.WARNINGIt is important to keep the power cord away from the compressor at theback of the freezer as during operation, the compressor can reach a hightemperature and could cause serious damage to the power cord.CAUTIONCare should be taken during the handling moving and use of the freezer toavoid damaging the refrigerant tubing or increasing the risk of a leak.SET UP & USEENGLISH