Black & Decker Amherst Price Pfister 49 Series Installation Instructions Manual

ENGLISHENGLISH7 91087 CONTROL BODY INSTALLATIONPlace a bead of plumber’s putty in the groove along the bottom outer edge of PlasticGasket (7A). Place Plastic Gasket (7A) against the bottom of Control Body (7B). Fromabove sink, insert Threaded Shank (7C) and Tubing (7D) through side hole of sink.From underneath sink, place Washer (7E) and Locknut (7F) through Hose (7G). Secure ControlBody (7B) by threading Locknut (7F) onto Threaded Shank (7C). Tighten loosely, make sureHandle (7H) swings equally in both directions. Tighten Control Body (7B) firmly to sink.Caution: Do not over tighten!8 HOSE ATTACHMENTPush Quick Connect Housing (8A), firmly upward onto the Receiving Tube (8B) locatedon the bottom of the Spout Body (8C), until unable to push any further. Pull down on theQuick Connect Housing (8A). If the housing and the Inner Collet (8D) separate slightlybut do not pull off, the Receiving Tube (8B) the connection is secure.To remove Hose (8D), push up on Quick Connect Housing (8A), holding Inner Collet(8D) in place, pull downward on Quick Connect Housing (8A) until Receiving Tube(8B) is free.9 SOAP DISPENSER INSTALLATIONInsert Soap Dispenser Shank (9A) through Foam Gasket (9B) and into the sink holes.[Both Control Body (9C) and Dispenser Shank (9A) can be placed in either end hole].From underneath sink, secure Soap Dispenser Shank (9A) by screwing Plastic Locknut(9D). Thread Bottle (9E) to Soap Dispenser Shank (9A). Hand tighten.Caution: do not over tighten!10 SOAP DISPENSER HEAD INSTALLATIONPour in liquid soap (not included) into Shank Orifice (10A). Insert Pump Mechanism(10B) into Soap Dispenser Shank (10C). Install Dispenser Head (10D) by pushing firmlyonto Pump Mechanism (10B).37A7B7E7G7F7C7H7D9A9B9DE9C10B10D10A10C8A8A8D 8D8A8B8A8B8B8C