Black & Decker 900143 User Manual

Contents

Model # 900143: Page 7OPERATIONThis unit is intended for water dispensing only. Do NOT use other liquids. Do NOTuse for other purposes.This dispenser has been designed to use water bottles with 3 & 5 gallon capacity.Do NOT use alternative bottles.Initial Set UpDo NOT plug in until steps 1-5 are completed.1. Allow unit to sit upright for 4 hours.2. Clean fresh water bottle with a soft cloth and warm soapy water, then rinse.3. Remove tamper seal from top of bottle cap. Do NOT remove plastic cap.4. Lift bottle and insert onto the probe. Apply slight pressure until the plug inside thecap pushes in and the bottle is seated.5. Wait 3 minutes then dispense some water from the HOT tap until air bubblesappear in the bottle.6. Plug cord into a properly grounded wall outlet.7. Turn energy saving switch on back to ON.Initial Rinsing of Water LinesThis unit has been tested and sanitized prior to packing and shipping. During transit dustand odors can accumulate in the tank and lines. Dispense and dispose at least onequart of water prior to drinking any water.Dispensing Cold WaterNote: After setup, it will take 1 hour to get water to maximum cold temperature. Duringthis time the compressor will run continuously. This is normal.1. Position bottle, glass, pitcher or cooking pot securely below cold water tap.– The blue arrowhead below the cold water control indicates the location of the coldwater tap.- The circular shapes in the drip plate help align the flow of water. This unitdispenses water at a fast rate. To avoid splashes, hold cup as close to the tap aspossible.2. Depress cold water control downward to start flow.3. Release cold water control once desired fill level is achieved.