Baroness LM18G Service Manual

Also see for LM18G Series: Owner's manual Installation manual

Baroness LM18G Service Manual Manual pdf 9 page image

66Required Tools*Tool sizes are indicated in mm.Notes for InspectionAlways refer to this service manual as well as the owner’s manual when inspecting the mower.During the inspection and operation of the mower, always wear gloves.“Left” and “right” directions in this manual are based on the viewpoint of the operator holdingthe handle of the mower and facing the mowing direction.When inspecting and repairing the mower, place it on a level surface and make sure all theparts are in OFF position.The build-up of cut grass and other debris at the intakes for engine cooling air and air cleaner,or the muffler and exhaust pipe could lead to engine malfunction and overheating which couldcause a fire. When you see this build-up, stop the operation immediately. After the heated areacools down enough, remove the build-up.Do not touch the muffler and engine either during or right after operation as those areas canbe dangerously hot. This could cause burns.Always keep clean the safety symbols and instructions attached to the mower. If they are lostor damaged, replace them immediately with new ones.Do not alter the machine. When replacing parts and grease, use those specified by KyoeishaUSA.The operation of a machine that has been altered or installed with parts other than thosespecified by Kyoeisha USA could lead to mechanical damage or accident.CAUTIONWARNINGScrew wrench 7 10 13 17 19 22 x 1 24 x 2Allen key wrench 2 5 6Longnose pliersPin remover 4Stop ring pliers For opening & closingScrewdriver Flathead x 2Slide gaugeClearance gauge (thickness gauge) 0.5 x 2 (included tool)Hammer Metal, wooden, plasticOther Magic marker, mowing height gauge, wastecloth, round barTool to hammer bearingsSupport to prevent engine oil from spillingwhen the engine tilts