Barefoot Sound MicroMain35 Gen2 Owner's Manual

Contents

Barefoot Sound MicroMain35 Gen2 Owner's Manual Manual pdf 5 page image

45. Startup1. Verify that the AC Voltage select switch on the rear panel is in the correct position for the AC voltage in yourfacility (see warnings on pervious page for details) then plug in grounded mains power cable.2. Set Input toggle switch to either analog (A) or digital (D) depending on the type of source signal you areusing. For digital signals also set the Channel toggle switch to left (L) or right (R) in accordance with thespeaker position.3. Ensure that the audio signal is fully attenuated (AES3 signal requires digital attenuation).4. Power on the speaker with the rocker switch located on the rear panel above the mains connector. The LEDindicator on the front of the speaker will illuminate Red for a couple of seconds then turn Aqua.5. Turn up the audio signal and enjoy!4. ConnectionsAnalog: Digital:Analog Source AES3 Source* See Section 9 for Voice connection details.AES/EBUSplitter

/ 17

Related manuals for Barefoot Sound MicroMain35 Gen2

Barefoot Sound MiniMain12 Owner's Manual

Barefoot Sound MicroMain45 User Manual

Barefoot Sound FOOTPRINT03 Owner's Manual

This manual is suitable for:

MicroMain35 Gen2

Barefoot Sound MicroMain35 Gen2 Owner's Manual

Product

Learn More

Legal