R5906112 /09 UDX series1128.7.2 Warping – Screen SizeAbout (Warp) Screen Size adjustmentIf the used source aspect ratio is different than the projector aspect ratio, e.g. source is 16:9 and projector is16:10, then black bars will be projected. In the example case a black bar on top and bottom of the image willbe projected. The warp area contains not only the image information but also the black bars. If we want toposition e.g. the active left top corner exactly on the screen using 4 corner warp, then it is very hard to do thatas we are moving the black left top corner and we do not have control over the exact position of image left topcorner. By moving the outline of the warp screen size to the active image information, the corner points of thewarp area are now exactly on the corner points of the active image information and makes warping mucheasier.Image 8-18: Warp outline exampleHow to adjust the image?1. In the main menu, select Installation → Warp → Screen Size.Image 8-19: Warp Menu, Screen SizeThe Screen Size menu is displayed.GUI – Installation
