Menu
Bansbach Easylift S4 Series Manual
    |
Controller EEL-S4The Bansbach S4 series is a range of battery-based actuator controllers developed especially for mobileapplications. The controller can manage up to 4 actuators with a wired handset and it is supplied byeither a NiMH Li-Ion-battery.The controller may be configured using PC software which may be ordered separately from Bansbach.This allows patterns of operation, stroke length, speed, etc. for the connected actuators to be adjusted.EEL-S4Battery Based Actuator Control SystemPreparationBefore the system may be used, the battery must be charged using the accom-panying charger. It takes 5-8 hours to fully charge a battery.The yellow LED lights up when the charger is connected to power. Place thebattery in the charger by sliding it in and rotating it until it is pulled into place bythe magnets. The green LED will flash at approx. 1 second intervals while thebattery is being charged. Once charging is complete the green LED remainspermanently lit. Remove the battery by rotating it 90 degrees. It will then beejected and be ready for use.Once the battery is fully charged, insert it into the controller. Follow the sameprocedure as for the charger. If everything is OK, the controller will simply sound a beep (one second)once the battery is in place. If the system has any faults, the beep will be followed by an error indicationaccording to table 1 below.When the battery requires recharging, transfer it to the charger as described above. It is recommendedthat you keep an extra battery on hand to avoid disruption to operation.Always wait at least two seconds after the last actuator has stopped moving before removing the battery.Otherwise the controller may not have time to store the position and it may be necessary to perform0-point calibration as described in section „Normal operation“.Input voltage: 24VDCOperating temperature: 5°C to 40°CRelative humidity: 20% to 70%Atmospheric pressure: 1atmMax. operating attitude: 2000mBattery technology: NiMH or Li-IonTechnical data and model designation:What is the EEL-S4?MANUAL |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved