Balance KH 5525 Instruction Manual

Also see for KH 5525: Instruction manual Instruction manual

Contents

Balance KH 5525 Instruction Manual Manual pdf 5 page image

- 3 -Intended UseThe Hair Straightener is intended for the smoothingand shaping of human hair, under no circumstancesmay it to be used for wigs and hairpieces made of syn-thetic material. The Hair Straightener is intended fordomestic use only. Pay heed to the information in thisoperating manual, especially the safety instructions.Items supplied• Hair Straightener KH 5525• Combination mounting• 2 narrow ceramic plates• 2 wide ceramic plates• Screws• Wall plugs• Operating manualAppliance descriptionq Control lamp/Viewing window for temperatureadjustmentw On/Off switche Power cable with plugr Rotary controller temperature adjustmentt Ceramic plate narrowy Ceramic plate wideu Securing holes for on-wall assemblyi Hair straightner retainero Retainer for ceramic platesa Combination mountingPlacing/Fixingthe combination mountingYou can either securely place the combination amounting or fix it to the wall.SetupPlace the combination mounting a on a level, dryand heat resistent surface.Wall mountingDanger!Ensure that there are no electric cables, gasand water pipelines or other facilities locatedunderneath the position at which you mightwish to affix the combination mounting a. Thereis a risk of receiving an injury or an electricshock should you bore holes at these posi-tions!1. Mark the boreholes on the wall.To do this hold the combination mounting a atthe desired position and, with a pencil or asharp object, mark the drilling locationsthrough the securing holes u.Take note that the markings need to be madethrough the upper, smaller part of the securingholes u.2. Bore holes at the marked positions and insertthe wallplugs into them.3. Turn the screws so far into the wallplugs thatca. 5 mm of the screwshafts continue to be ex-posed.4. Place the combination mounting a over thescrews so that they protrude through the secu-ring holes u.5. Press the combination mounting a down sothat the screwshafts are now in the narrow partof the securing holes u.6. Tighten both screws down.