Badger Meter MDS2000 User Manual

Also see for MDS 2000: User manual Installation and software manual

Badger Meter MDS2000 User Manual Manual pdf 40 page image

Important safety instructions Page 37/62LMS_MDS2000_BA_99_10021. Important safety instructions1. Before installing or using this product, please read the instruction manualthoroughly.2. Unpacking: Please check that the product is complete and free from any damage(check with the further packing list).3. Only qualified individual should install and/or repair this product.4. Unplug the MDS 2000 from the electrical outlet before you clean it. Use a clampcloth for cleaning and do not use liquid or aerosol cleaners.5. Do not place the MDS 2000 on an unstable surface that may allow the unit to fall.6. Never place the MDS 2000 near or over a radiator or heat register.7. Use the type of power source indicated on the label (AC power). If you are not sureof the type of power available, consult your supplier or local electric company.8. The MDS 2000 must be equipped with a plug having a third (grounding) pin, whichfits only into a grounding-type outlet. This is a safety feature. The MDS 2000 shouldnot be used without a properly grounded outlet. Failure to properly ground the MDS2000 may cause damage to the unit or the data stored.9. Do not put the MDS 2000 where the cord will be walked on.10. An extension cord is not recommended for use with the MDS 2000. If you use anextension cord, make sure that the total of the ampere ratings on the productsplugged into the extension cord does not exceed the extension cord's ampererating. Also, make sure that the total of all products plugged into the wall outlet doesnot exceed 15 amperes.11. Unplug the MDS 2000 from the wall outlet and have it repaired by a qualifiedservice person under the following conditions:a) When the power cord or plug is damaged or frayed.b) If liquid has been spilled into it.c) If it has been exposed to rain or water.d) If it does not operate normally when the operating instructions are followed.Adjust only those controls that are covered by the operating instructions sinceimproper adjustment of other controls may result in damage and loss of data.e) If it has been dropped or damaged.f) If it exhibits a distinct change in performance, indicating a need for service.WarningFailure to adhere to these safety instructions may result in serious bodily injury.