Baby Trend FLEX-LOC Owner's Manual

Also see for EZ FLEX-LOC: Owner's manual Owner's manual Owner's manual

Contents

Baby Trend FLEX-LOC Owner's Manual Manual pdf 25 page image

proper angle of recline, place a rolledtowel, or car seat noodle, under thebase at the foot end to achieve thecorrect position. (Fig. 48-1)2. Safety Seat without Base: Checkthat the Safety Seat is level side to sideon the vehicle seat. Check the levelindicator as shown in Fig. 46-2.• If the Seat Angle Indicator shows NOred, the seat is installed at the properlevel of recline.• If the Seat Angle Indicator shows ANYred, the Safety Seat is either too uprightor too reclined. If the Safety Seat istoo reclined adjust the Safety Seat asshown in Fig. 48-2 until the level indicatorshows NO red. If the Safety Seat is tooupright, place a tightly rolled towel, orcar seat noodle, under the foot end ofthe Safety Seat until the level indicatorshows NO red. (Fig. 48-3) Re-tighten thevehicle seat belt as instructed in sectionSecuring the Safety Seat or Base inthe Vehicle.7.0 INSTALLATION4948Fig. 48-1Fig. 48-2Fig. 48-38.0 FINAL CHECKSFINAL SAFETY CHECKS1. If your child is already in the Safety Seat, check that theharness is properly fitted and tight as instructed in the section6.1, Securing your Child in the Safety Seat / Carrier.2. Make sure that the Safety Seat is tightly installed and securein the vehicle by performing the following test every time youuse the Safety Seat. Firmly push down and side to side onthe head end of the Safety Seat to make sure that the vehicleseat belt does not loosen at all and that the vehicle seat belt isfastened very tightly around the Safety Seat / Base. If you findthat the vehicle seat belt loosens or that the seat easily movesor rotates downward, please see section entitled Selecting theBest Location for the Safety Seat to determine if the positionyou have selected is adequate and check that you havecompleted all of the steps in the section entitled Securing theSafety Seat or Base in the Vehicle.DO NOT use this seating location if the Safety Seat does notremain tightly installed in the vehicle seat!3. Remove any toys or other objects attached to carry handle4. Adjust carry handle into desired adjustment position.

/ 27

Related manuals for Baby Trend EZ FLEX-LOC