Menu
Aztec 16 Operation And Maintenance Manual
Also see for ROPEVENTURE 4: Assembly instructions
              |
- 1 -Version 1-2000November 2000OPERATION AND MAINTENANCE MANUALFOR TX 2, 4, 8, 16, 32LOW PROFILE HYDRAULIC TORQUE WRENCHESSeries TX-2, TX-4, TX-8, TX-16 and TX-32 Low Profile Hydraulic Torque Wrenches are designed forinstalling and removing large bolts having minimal wrench clearance at offshore platforms, powerplants, steel erection sites and other locations requiring precise high torque during bolt makeup andmaximum torque for bolt breakdown.Aztec Bolting Services is not responsible for customer modification of tools for applications on whichAztec Bolting Services was not consulted.IMPORTANT SAFETY INFORMATION ENCLOSED.READ THIS MANUAL BEFORE OPERATING TOOL.IT IS THE RESPONSIBILITY OF THE EMPLOYER TO PLACE THE INFORMATION IN THISMANUAL INTO THE HANDS OF THE OPERATOR.FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.PLACING TOOL IN SERVICE• Always operate, inspect and maintain this tool inaccordance with American National Standards SafetyCode for Hydraulic Rams and Jacks (ANSI B30.1)• This tool will function using an air or electric poweredhydraulic pump. Adhere to the pump safetyrequirements and follow instructions when connectingthe pump to the tool.• Use only equipment rated for the same pressure andtorque.• Use only a hydraulic pump capable of generating10,000 psig (681 bar) maximum pressure with this tool.• Use only twin line hydraulic hose rated for 10,000 psig(681 bar) pressure with this tool.• Do not interchange the male and female swivel inletson the tool or the connections on one end of the hose.Reversing the inlets will reverse the power stroke cycleand may damage the tool.• Do not use damaged, frayed or deteriorated hoses andfittings. Make certain there are no cracks, splits orleaks in the hoses.• Use the quick connect system to attach the hoses to thetool and pump. Make certain the spring-loaded retainingrings are fully engaged and the safety rings are tightlythreaded against the spring-loaded retaining rings toprevent the connectors from disengaging under pressure.• When connecting hoses that have not been preloadedwith hydraulic oil, make certain the pump reservoir isnot drained of oil during start-up.• Do not remove any labels. Replace any damaged labels.USING THE TOOL• Do not handle pressurized hoses. Escaping oil underpressure can penetrate the skin, causing serious injury. Ifoil is injected under the skin, see a doctor immediately.• Never pressurize uncoupled couplers. Only usehydraulic equipment in a coupled system.• Always wear eye protection when operating orperforming maintenance on this tool..• Always wear head and hand protection and protectiveclothing when operating this tool.The use of other than genuine replacement parts may result in safety hazards, decreased tool performance, andincreased maintenance, and may invalidate all warranties.Repairs should be made only by authorized personnel. Refer all communications to Aztec Bolting ServicesPrinted in U.S.A.NOTICENOTICEWARNINGFor Technical Support and Information Contact:Aztec Bolting Services, Inc.520 Dallas StreetLeague City, TX 77573Toll Free: (800) 233-TORKFax: (281) 332-1780E-mail: techsupport@bolting.com |
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved