96Notebook PC E-Manual• Connect the equipment into an outlet on a circuit different from that towhich the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.WARNING! The use of a shielded-type power cord is required in order to meetFCC emission limits and to prevent interference to the nearby radio and televisionreception. It is essential that only the supplied power cord be used. Use only shieldedcables to connect I/O devices to this equipment. You are cautioned that changes ormodifications not expressly approved by the party responsible for compliance couldvoid your authority to operate the equipment.(Reprinted from the Code of Federal Regulations #47, part 15.193, 1993.Washington DC: Office of the Federal Register, National Archives and RecordsAdministration, U.S. Government Printing Office.)FCC Radio Frequency (RF) Exposure CautionStatementWARNING! Any changes or modifications not expressly approved by the partyresponsible for compliance could void the user’s authority to operate this equipment.“The manufacture declares that this device is limited to Channels 1 through 11 in the2.4GHz frequency by specified firmware controlled in the USA.”This equipment complies with FCC radiation exposure limits set forth for anuncontrolled environment. To maintain compliance with FCC RF exposurecompliance requirements, please avoid direct contact to the transmitting antennaduring transmitting. End users must follow the specific operating instructions forsatisfying RF exposure compliance.