QuickInstallationGuideA quick lookFive LAN Gigabit portsUSB 3.0 port x 1WPS button x 1Power on off button x 1Wi-Fi LED:2.4G LED / 5G LED:Three LEDs on: RP-AC68U has good signalconnection with router.Two LEDs on: RP-AC68U has normalsignal connection with router.One LEDs on: RP-AC68U has weak signalconnection with router.Off: RP-N12 doesn’t connect to a router.Plug your RP-AC68U into apower outlet Near yourRouter/APMethod One Quick Setup using the WPS ButtonUse this if your Router or Access Point(AP) support WPSPower On Push the two WPS buttonsPush the WPS button on yourRouter/APImmediately push the WPSbutton on your RP-AC68UThe Stylish LED should go toflashing in about 2 minutes.Wait until the Wi-Fi LED turnon. You could know thesignal quality with differentLED number.Relocate RP-AC68U to a location you like.After the extender is relocated to a new place, RP-AC68U will reconnect to your router automatically in about one minute.The ideal location for RP-AC68U is between your wirelessrouter and wireless device.Make sure RP-AC68U is in a location where signalsindictor LED has over 2 led on at least.Keep the RP-AC68U away from devices like cordlessphones, Bluetooth devices and microwave ovens tominimize wireless interference.If possible, try to place your extender in opencorridors or spacious locations rather than acrowded room.Enjoy!The Range Extender shares your router’s Wireless Network Name (SSID) andWireless PasswordFrequently Asked Questions (FAQ)Q1: What should I do if my router doesn’t have a WPS button?A1: You can use Method Two to set up RP-AC68UQ2 Why is that the Wi-Fi LED does not light up after completing Method Two?A1: You may have entered the wrong router SSID and password. Reset your RP-AC56,double check your router SSID/password, and set up RP-AC56 again.Q3 How do I reset RP-AC68UA1: Press the RESET button on the button of RP-AC68U for about two (2)seconds. Wait for about five (5) seconds until the LEDs blink slowly.RP-AC68UDual band Wireless Ranger ExtenderReset button