2-2Chapter 2: Boot Agent Configuration2.1 Intel(R) Boot Agent XEThe Intel(R) Boot Agent XE provides hardware-based Ethernet card configurations.To start the Intel(R) Boot Agent XE and access the main screen:1. Turn on the system.2. During POST, press when the following screen appears.3. From the Setup Menu screen, use the Up/Down arrow key to select an item and press to change the value.Initializing Intel(R) Boot Agent XE v2.3.58PXE 2.1 Build 092 (WfM 2.02)Press Ctrl-S to enter Configuration MenuIntel(R) Boot Agent XE v2.3.58Setup MenuNetwork Boot Protocol PXE (Preboot eXecution Enviroment)Boot Order Use BIOS Setup Boot OrderShow Setup Prompt EnabledSetup Menu Wait Time 2 secondsDiagnostic Support InformationMAC Address 00E018122209 PBA Number FFFFFF-0FFMemory DE180000 I/O E0000 IRQ 0A UMB C9000PCI ID 8086/1563/1043/8712/01 Slot 0100Flags 01810:4000:0000:0000:1103:LSelect remote boot protocol. Cancel Changes Change Value Next Option Save ConfigurationNetwork Boot ProtocolThis item allows you to select the boot protocol.Configuration options: [PXE (Preboot eXecution Enviroment)]Boot OrderThis item allows you to select the order in which boot devices are queried.Configuration options: [Use BIOS Setup Boot Order]Show Setup PromptThis item allows you to select whether Ctrl+S message appears during initialization.Configuration options: [Disabled] [Enabled]Setup Menu Wait TimeThis item allows you to select the number of seconds to wait for Ctrl+S during initialization.Configuration options: [0 seconds] [2 seconds] [3 seconds] [5 seconds]
