Asus Lyra MAP-AC2200 Quick Start Manual

Also see for Lyra MAP-AC2200: Quick start guide Quick install Quick start guide

Colors of LyraLight CyanEverything is good!RedLoss connection to the primary Lyra. Move it closer.Quick Start GuideLyra1Connect Primary Lyra to ModemConnect your modem to Lyra with thenetwork cable provided.Unplug your cable / DSLmodem*. Remove thebattery if it has one.* If you are using DSL forinternet, you will needa username/passwordfrom your Internetservice provider (ISP) toproperly configure yourrouter.Power on your cable / DSL modem, andcheck your cable / DSL modem LED lightsto ensure the connection is active.Plug in the power adapter to Lyra andwait until the LEDs turn to solid white toensure that your Lyra is ready for setup.Primary Lyra2Setup your Lyra WiFi systemMETHOD 1 Through AppDownload the free ASUS Lyra app.Launch the ASUS Lyra app on your mobiledevice, and follow the instructions in justa few moments.* Make sure your device supports BLE,Bluetooth 4.0 or above.Connect PC/NB to your Lyra via WiFi“ASUS_XX_AMAPS”. Open a web browser.You will be redirected to the ASUS SetupWizard. If not, navigate to http://router.asus.comMETHOD 2 Through Web GUIPrimary LyraLaunch Lyra app and click the “+” icon onthe upper right corner, then choose AddLyra to current network and follow theinstructions to complete.Adding other Lyra to current networkPress the Pairing button on the Primary Lyrauntil the LED starts to blink green light.Primary LyraPress the Pairing button on the second Lyrauntil the LED starts to blink green light, thenturns solid light cyan, indicating the pairingprocess is completed.METHOD 2 Through Web GUIMETHOD 1 Through App3OrangeLoss connection to the Internet. Please check the cable connected with your modem.Solid WhiteLyra is ready for setup. It will start blinking when setting up with the app.Random BreathingLyra is booting up or applying settings.S13319 / Primera edición/ Septiembre 2017Federal Communications CommissionStatementThis device complies with Part 15 of the FCC Rules. Operation issubject to the following two conditions:• This device may not cause harmful interference.• This device must accept any interference received, includinginterference that may cause undesired operation.This equipment has been tested and found to comply with the limitsf or a class B dig ital device, pursuant to part 15 of the FCC Rules.These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipmentgenerates, uses and can radiate radio frequency energy and, if notinstalled and used in accordance with the instructions, may causeharmful interference to radio communications. However, there is noguarantee that interference will not occur in a particular installation. Ifthis equipment does cause harmful interference to radio or televisionreception, which can be determined by turning the equipment off andon, the user is encouraged to try to correct the interference by one ormore of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different fromthat to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.WARNING!Any changes or modifications not expressly approved by the partyresponsible for compliance could void the user’s authority to operatethe equipment.Prohibition of Co-locationThis device and its antenna(s) must not be co-located or operating inconjunction with any other antenna or transmitter.This equipment must be installed and operated in accordance withprovided instructions and the antenna(s) used for this transmitter mustbe installed to provide a separation distance of at least 20 cm from allpersons and must not be co-located or operating in conjunction withany other antenna or transmitter.IMPORTANT NOTE:Radiation Exposure Statement: This equipment complies with FCCradiation exposure limits set forth for an uncontrolled environment.End users must follow the specific operating instructions for satisfyingRF exposure compliance. To maintain compliance with FCCexposure compliance requirement, please follow operationinstruction as documented in this manual.This device within the 5.15 ~ 5.25 GHz is restricted to indooroperations to reduce any potential for harmful interference toco-channel MSS operations.Radio Frequency (RF) ExposureInformationThe radiated output power of the ASUS Wireless Device is belowthe Industry Canada (IC) radio frequency exposure limits. TheASUS Wireless Device should be used in such a manner suchthat the potential for human contact during normal operation isminimized.This device has been evaluated for and shown compliant withthe IC Specific Absorption Rate (“SAR”) limits when installed inspecific host products operated in portable exposure conditions(antennas are less than 20 centimeters of a person’s body).This device has been certified for use in Canada. Status of thelisting in the Industry Canada’s REL (Radio Equipment List) can befound at the following web address:http://www.ic.gc.ca/app/sitt/reltel/srch/nwRdSrch.do?lang=engAdditional Canadian information on RF exposure also can befound at the following web: http://www.ic.gc.ca/eic/site/smt-gst.nsf/eng/sf08792.htmlRF Exposure informationThis device meets the EU requirements (2014/53/EU) on thelimitation of exposure of the general public to electromagneticfields by way of health protection.Safety Notices• Use this product in environments with ambient temperaturesbetween 0°C(32°F) and 40°C(104°F).• Refer to the rating label on the bottom of your product andensure your power adapter complies with this rating.• DO NOT place on uneven or unstable work surfaces. Seekservicing if the casing has been damaged.• DO NOT place or drop objects on top and do not shove anyforeign objects into the product.• DO NOT expose to or use near liquids, rain, or moisture. DO NOTuse the modem during electrical storms.• DO NOT cover the vents on the product to prevent the systemfrom getting overheated.* Pairing feature only works with the Primary Lyradevice connecting to modem.* While setting up through Web GUI, ensure thatyou pair other Lyra hub(s) with the Primary Lyrausing the Pairing button.S13319_Lyra_one-page_QSG_with_Safety_Notices.indd 1 2017/9/21 16:29:32

/ 2

Related manuals for Asus Lyra MAP-AC2200