Asus HG100 User Manual

Also see for HG100: Quick start guide

User ManualFederal Communications Commission Interference StatementThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCCRules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with theinstructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will notoccur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can bedetermined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures:-Reorient or relocate the receiving antenna.-Increase the separation between the equipment and receiver.-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.-Consult the dealer or an experienced radio/ TV technician for help.CAUTION! Any changes or modifications not expressly approved by the grantee of this device could void theuser’s authority to operate the equipment.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may notcause harmful interference, and (2) this device must accept any interference received, including interference that may causeundesired operation.RF exposure warningThis equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for thistransmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located oroperating in conjunction with any other antenna or transmitter. End-users and installers must be provide with antenna installationinstructions and transmitter operating conditions for satisfying RF exposure compliance.Canada, avis d’Industry Canada (IC)Cet appareil est conforme avec Industrie Canada exemptes de licence RSS standard(s).Son fonctionnement est soumis aux deux conditions suivantes : (1) cet appareil ne doit pas causer d’interférence et (2) cetappareil doit accepter toute interférence, notamment les interférences qui peuvent affecter son fonctionnement.Canada, Industry Canada (IC) NoticesThis device complies with Canada licence-exempt RSS standard(s).Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must acceptany interference, including interference that may cause undesired operation of the device.156