Asus GigaX 1016 User Manual

Contents

4Rear PanelThe rear panel includes a three-prong universal power plug. The inputpower is 100-240V AC /50-60Hz.Figure 3. Rear panelPlacement optionsPlace the GigaX1016 Switch on a flat and stable surface. Make sure thelocation meets the operating environment specifications. See page 6 fordetails.NOTE: The maximum cable length of UTP Category 5 is 100 meters(328 feet).Connecting network devicesFollow these steps to connect network devices to the GigaX1016 Switch:1. Connect one end of the Ethernet cable to an Ethernet port on the Switchfront panel. Connect the other end to the Ethernet port of the networkdevice. Repeat this step to connect additional network devices.2. Plug one end of the power cable to the power connector on the Switchrear panel, then plug the other end to an electrical outlet.3. The Power LED and LED indicators for active Ethernet ports light up toindicate that the device is on and in use. Refer to the LED table in page3 for indications.