ASUS ESC4000 G4 Series6-9Select a destination disk with the same size as the original hard disk.6.2.5 Rebuilding the RAIDThis option is only for the RAID 1 set.Rebuilding the RAID with other non-RAID diskIf any of the SATA hard disk drives included in the RAID 1 array failed, the system displaysthe status of the RAID volume as “Degraded” during POST. You can rebuild the RAID arraywith other installed non-RAID disks.To rebuild the RAID with other non-RAID disk:1. During POST, press + at the prompt to enter the Intel Rapid StorageTechnology option ROM utility.2. If there is a non-RAID SATA Hard Disk available, the utility will prompt you to rebuildthe RAID. Press the up/down arrow keys to select the destination disk then press to start the rebuilding process, or press to exit.6.2.4 Exiting the Intel® Rapid Storage Technology enterpriseSATA/SSATA Option ROM utilityTo exit the utility:1. From the utility main menu, select 4. Exit then press .2. Press to exit or press to return to the utility main menu.Select the port of destination disk for rebuilding (ESC to exit):Port Drive Model Serial # SizeX XXXXXXXXXXX XXXXXXXX XXX.GB“Degraded” volume and disk available for rebuilding detected. Selectigna disk initiates a rebuild. Rebuild completes in the operating system.[ ]-Previous/Next [ENTER]-Select [ESC]-Exit[ DEGRADED VOLUME DETECTED ]Are you sure you want to exit? (Y/N):[ CONFIRM EXIT ]
