5-28 Chapter 5: BIOS setup5.4.11 WHEA ConfigurationEnable or disable WindowsHardware Error Architecture.WHEA Support [Enabled]WHEA Support [Enabled]Allows you to enable or disable the Windows Hardware Error Architecture support.Configuration options: [Disabled] [Enabled]5.4.12 APM settingSpecify what state to go towhen power is re-applied aftera power failure (G3 state).Restrore AC Power Loss [Last State]Power On By PCIE [Disabled]Power On By Ring [Disabled]Power On By RTC [Disabled]Restore AC Power Loss [Last State]When set to [Power Off], the system goes into off state after an AC power loss.When set to [Power On], the system will reboot after an AC power loss. When setto [Last State], the system goes into either off or on state, whatever the systemstate was before the AC power loss.Configuration options: [Power Off] [Power On] [Last State]Power On By PCIE [Disabled][Disabled] Disables the PCIE devices to generate a wake event.[Enabled] Enables the PCIE devices to generate a wake event.Resume On By Ring [Disabled]When set to [Enabled], the system will generate a wake event when the externalmodem receives a call while the computer is in Soft-off mode.Configuration options: [Disabled] [Enabled]Power On By RTC [Disabled][Disabled] Disables RTC to generate a wake event.[Enabled] When set to [Eanbled], the items RTC Alarm Date (Days) andHour/Minute/Second will become user-configurable with setvalues.Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.AdvancedAptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.Advanced
