Asus E2224 User Manual

Also see for A3Ac: User guide User guide User guide User guide User guide

Contents

62A Appendix(Reprinted from the Code of Federal Regulations #47, part 15.193, 1993. Washington DC: Office of theFederal Register, National Archives and Records Administration, U.S. Government Printing Office.)Canadian Department of Communications StatementThis digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatusset out in the Radio Interference Regulations of the Canadian Department of Communications.This Class B digital apparatus complies with Canadian ICES-003.(Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.)CE Mark WarningThis is a Class B product, in a domestic environment, this product may cause radio interference, inwhich case the user may be required to take adequate measures.WARNING! The use of a shielded-type power cord is required in order to meet FCCemission limits and to prevent interference to the nearby radio and television recep-tion. It is essential that only the supplied power cord be used. Use only shieldedcables to connect I/O devices to this equipment. You are cautioned that changes ormodifications not expressly approved by the party responsible for compliance couldvoid your authority to operate the equipment.Federal Communications Commission StatementThis device complies with FCC Rules Part 15. Operation is subject to the following two conditions:• This device may not cause harmful interference, and• This device must accept any interference received, including interference that may cause undesired operation.This equipment has been tested and found to comply with the limits for a class B digital device, pursuantto Part 15 of the Federal Communications Commission (FCC) rules. These limits are designed to providereasonable protection against harmful interference in a residential installation. This equipment generates,uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruc-tions, may cause harmful interference to radio communications. However, there is no guarantee that inter-ference will not occur in a particular installation. If this equipment does cause harmful interference toradio or television reception, which can be determined by turning the equipment off and on, the user isencouraged to try to correct the interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.