ROG Blitz Formula 4-33Chassis Q-Fan Control [Disabled]Allows you to enable or disable the chassis Q-Fan controller.Configuration options: [Disabled] [Enabled]The following two items appear when you enable the Chassis Q-Fan Controlfeature.Chassis Fan Ratio [Auto]Configuration options: [Auto] [90%] [80%] [70%] [60%]Chassis Target Temperature [21ºC]Configuration options: [12ºC] [15ºC] [18ºC] [21ºC] [24ºC] [27ºC] [30ºC]Chassis Fan 4 Speed [xxxxRPM] or [Ignored] / [N/A]The onboard hardware monitor automatically detects and displays thechassis fan speed in rotations per minute (RPM). If the fan is not connectedto the motherboard, the field shows N/A.OPT Fan and Power FanSelect ScreenSelect Item+- Change FieldF1 General HelpF10 Save and ExitESC ExitOPT_Fan 1 Speed :N/AOPT_Fan1 Q-Fan Control [DUTY CYCLE]Duty Cycle Mode [90%]OPT_Fan 2 Speed :N/AOPT_Fan2 Q-Fan Control [DUTY CYCLE]Duty Cycle Mode [90%]Power Fan Speed :N/AFan configurationmode settingBIOS SETUP UTILITYPowerv02.58 (C)Copyright 1985-2007, American Megatrends, Inc.The onboard hardware monitor automatically detects the optional fan speed. If thefan is not connected to the motherboard, the field shows N/A.OPT_Fan1/2 Q-Fan Control [DUTY CYCLE]Allows you to select the optional fan control mode. When this item is set to[DUTY CYCLE], you can configure the Duty Cycle Mode item. If you set thisitem to [Q-FAN], you are allowed to configure the TargetTemp Value item.The Q-Fan detects the temperature of the fan connected to the OPT_FAN1/2connector and adjusts the fan speed.Configuraiton options: [DUTY CYCLE] [Q-FAN]You need to connect the thermal sensor cables to the OPT_TEMP1/2connectors to enable this function.
