Asus ASMB3-SOL User Manual

Also see for ASMB3-SOL: User guide

Contents

ASUS ASMB3-SOL PLUS 2-217. Configure your (a) subnet mask and (b) gateway address if needed.(a) Type asmc2 -kcs 30 01 01 05 FF FF FF 00 (your subnet maskencoded in hexadecimal system)(b) Type asmc2 -kcs 30 01 01 0C 0A 0A 0A FE (your gateway addressencoded in hexadecimal system)Refer to Appendix if you have trouble converting your subnet mask/gatewayaddress to hexadecimal value representation.8. Type asmc2 -init_asmb to effect the configuration.9. Type asmc2 -bmc_info on the prompt, then press to display the BMCand PET IP and MAC addresses.10. Restart the remote server, enter the BIOS setup, then boot from the hard diskdrive.11. Configure the ASMB3-SOL PLUS baud rate (asmc2 -sol_baud 57600).Firmware Version : 1.01 (DSBF-D/SAS, DSBF-D, DSBV-D, DSCC-D12/SAS, DSCC-D12,DSCC-DWBMC IP : 10.10.10.10BMC MAC : 00 E0 18 51 10 7APET IP : 00.00.00.00PET MAC : 00 00 00 00 00 00SOL BAUD: 57600Make sure that the ASMB3-SOL PLUS baud rate is the same as the RemoteAccess baud rate that you previously set in the BIOS. See section 2.4 BIOSremote console for details.12. Adjust the local/central server network settings, if necessary.