36 ASUS A7V User’s ManualConnectors3. H/W SETUP3. HARDWARE SETUP12) Wake-On-LAN Connector (3-pin WOL_CON)This connector connects to a LAN card with a Wake-On-LAN output, such asthe ASUS PCI-L101 Ethernet card (see 7. Appendix). The connector powers upthe system when a wakeup packet or signal is received through the LAN card.IMPORTANT: This feature requires that Wake-On-LAN features are enabled(see 4.5.1 Power Up Control) and that your system has an ATX power supplywith at least 720mA +5V standby power.A7V Wake-On-LAN ConnectorIMPORTANT: Requires an ATX powersupply with at least 720mA +5 voltstandby powerWOL_CON+5 Volt StandbyPMEGround0 10 10 1A7V13) Wake-On-Ring Connector (2-pin WOR)This connector connects to internal modem cards with a Wake-On-Ring output.The connector powers up the system when a ringup packet or signal is receivedthrough the internal modem card. NOTE: For external modems, Wake-On-Ringis detected through the COM port.IMPORTANT: This feature requires that Wake-On-Ring features are enabled(see 4.5.1 Power Up Control) and that your system has an ATX power supplywith at least 720mA +5V standby power.A7V Wake-On-Ring ConnectorWORRing# Ground2 10 10 10 1A7V