Agrowtek SXW Instruction Manual

Agrowtek SXW Instruction Manual Manual pdf 4 page image

© Agrowtek Inc. | www.agrowtek.com | Technology to Help You Grow™4Assemble Mounting BracketOptional stainless steel pole mounting bracket allows all weather station components to be mounted on asingle pole for simple installation. It is recommended to mount the base of the pole on a hinge point so thatthe sensor array can be tipped down to ground elevation for service without a ladder.143221123Install Wind Sensors1. Insert direction vane and anemometer bracketsinto slots located in the top of the bracket (2).2. Using the provided screw and nut kit, fasten thewind sensors to the bracket through the holes inthe brackets.3. Route wires through the grommet in the top ofthe mounting bracket.Install SXW Sensor1. Remove the top cover from the SXW sensor andlocate the 7/8” diameter hole in the bottom of theenclosure.2. Assemble the stand-off pipe (1) through thehole and secure with included EMT nut (2).Note: hand tighten nut, then turn pipe to tighten.Note: circuit board may be removed temorarily toincrease access to the nut if required.3. Install pipe and sensor assembly into bracketmounting hole (3) and secure with EMT nut.4. Route RJ-45 cable from sensor circuit boardthrough stand-off pipe.5. Route wind sensor cables into sensor throughstand-off pipe (1). Keep cables under protectivecover (4) area to shield from sun and rain.Mount on Pole1-3/8” diameter clamps for 1” conduit or PVC pipe clamps secure with nuts on the back side of the bracket.Route the RJ-45 GrowNET™ cable through the pole to shield it from weather.