Aegis Padlock Quick Start Manual

Aegis Padlock Quick Start Manual Manual pdf 1 page image

Aegis Padlock SSD312UNLOCK buttonLED Indicator lightsLOCK buttonWhen you first plug in the Aegis Padlock SSD,the unit will do a self-test to verify all securitycomponents are working properly. The LEDs willgo through 3 test stages: RED, GREEN, andBLUE. This will be followed by three GREENblinks indicating all components are functioningproperly. A test failure will leave the unit in aninoperable state indicated by a blinking RED LED.First Time UseBefore the Padlock SSD can be used, the Admin PIN MUST be set. The LEDs will glowSolid BLUE and Solid GREEN to indicate the Padlock SSD is waiting for an Admin PIN tobe set.To Set-up the Admin PIN:1. Press + 9 simultaneously. The LEDs will be Constant BLUE / Blinking GREEN.2. Enter the new Admin PIN and press the key. If accepted, the BLUE LED will turnoff, the GREEN LED will blink three times, and then will return to Solid BLUE andBlinking GREEN.3. Re-enter that Admin PIN and press the key again. If accepted, the GREEN LED willglow solidly for three seconds.4. The BLUE LED will glow solidly indicating the drive is in Admin mode and will remainthat way for 30 seconds or until the key is pressed, either of which will return thedrive to its standby (locked) state.5. The Admin PIN is now set and will allow access to the drive or the Admin features.6. To access the drive’s data using the Admin PIN, press the button, then enter thenew Admin PIN and press .Note:PINs must be a minimum length of 7 maximum 16 digits.Cannot contain all consecutive numbers (2345678 or 9876543)Cannot contain all same number (1111111)The SHIFT key can be used for additional combinations.SHIFT + 1 are a separate value than just 1.NOTE: if you are using the Aegis Configurator (sold separately) to set up yourAegis Padlock SSD, First ensure that the device to be configured has the“configurable” logo on the belly label. Also, DO NOT perform the following ManualAdmin and USER PIN SETUP steps below; The Aegis Configurator will only recognizedevices in their factory “out of box” state or devices that have been completely reset.CONFIGURABLEQuick Start Guide2311 2ABC3DEF4GHI5JKL6MNO7PQRS8TUV9WXYZ0