29 Chapter 2The MIC-3369C supports one CompactFlash socket through the CN9connector. It helps file and data storage in the CompactFlash card ratherthan the traditional hard drive.2.10 Card InstallationThe CompactPCI connectors are firm and rigid, and require careful han-dling while plugging and unplugging. Improper installation of a card caneasily damage the backplane of the chassis. The install/eject handles ofthe MIC-3369C help you install and remove the card easily and safely.Follow the procedure below to install the MIC-3369C into a chassis:To install a card:1. Hold the card vertically. Be sure that the card is pointing in the correctdirection. The components of the card should be pointing to the right-hand side.2. Pull out both handles to unlock it.Caution: Keep your fingers away from the hinge to prevent your fin-gers from getting pinched.3. Insert the card into the chassis by sliding the upper and lower edges ofthe card into the card guides.4. Push the card into the slot gently by sliding the card along the cardguide until the handles meet the rectangular holes of the cross rails. Note:If the card is correctly positioned and has been slid all the way into thechassis, the handle should match the rectangular holes. If not, remove thecard from the card guide and repeat step 3 again. Do not try to install acard by forcing it into the chassis.5. Pull the upper handle down and lift the lower handle up to push thecard into place.6. Secure the card by pushing in the red handle to lock it into place.To remove a card:1. Unscrew the screws on the front panel.2. Lift the upper handle up and press the lower handle down to release thecard from the backplane.3. Slide the card out.
