OneStart

Menu

Advanced RF TECHNOLOGIES Epoch-M1C series User Manual

Page 1 preview
Page 2 preview
Page 3 preview
Page 4 preview
Page 5 preview
Page 6 preview
Page 7 preview
Page 8 preview
Page 9 preview
Page 10 preview
Page 11 preview
Page 12 preview
Page 13 preview
Page 14 preview
Page 15 preview
Page 16 preview
Page 17 preview
Page 18 preview
Page 19 preview
Page 20 preview
Page 21 preview
Page 22 preview
Page 23 preview
Page 24 preview
Page 25 preview
Page 26 preview
Page 27 preview
Page 28 preview
Page 29 preview
Page 30 preview
Page 31 preview
Page 32 preview
Page 33 preview
Page 34 preview
Page 35 preview
Page 36 preview
Page 37 preview
Page 38 preview
Contents
  1. Table Of Contents
  2. Table Of Contents
  3. Introduction of Epoch-M1C
  4. Available Models
  5. Warnings and Hazards
  6. Epoch-M1C Parts List
  7. Pre-Installation using Epoch-M1C Software
  8. Step by Step Instructions for Installation
  9. User Manual V1.0 using Epoch-M1C Software
  10. Control Menu
  11. Alarm Setting Window
  12. System Menu
  13. Upgrade Window
  14. Using the Epoch-M1C Software
  15. Alarms
  16. Downlink/Uplink Alarms
  17. Default Alarm Setting
  18. Maintenance Guide for Epoch-M1C
  19. Troubleshooting
  20. Common Installation Problems
  21. Warranty and Repair Policy
  22. Return Material Authorization (RMA)
  23. Appendix A: Specifications
  24. Appendix B: Button Operation
  25. Advanced RF Technologies, Inc. Proprietary Document
Advanced RF TECHNOLOGIES Epoch-M1C series User Manual Manual pdf 25 page image
Epoch-M1C RF RepeaterUser Manual V1.1Advanced RF Technologies, Inc. Proprietary Document Page 25 of 382.2 Using the Epoch-M1C Software2.2.1 Changing ParametersIn changing the parameters of the repeater using the Epoch-M1CSoftware, note that the values entered into the Epoch-M1C Software arelimited to the ranges and modes specified in the Menu Structure sectionas explained in Section 2.1 on page 15.The chart below shows the parameters that can be changed and thelocation of each parameter in the Control Menu Structure. The asterisk“*” denotes parameters that apply to both uplink and downlink.2.3 AlarmsAll the various alarms that are supported by Epoch-M1C can be viewed by clickingthe “Alarm” button on the Status Window. If a soft or hard fail alarm should occur,the corresponding alarm box would be highlighted in yellow or in red respectively.In order to find out what is causing the alarm(s), simply place the mouse cursor overthe highlighted yellow or red alarm box(Note: only applicable to some of the alarms)and a message will appear, displaying the threshold value and the current measuredvalue. To update the window, click the “Refresh” button.Control MenuGeneralSettingAlarmSettingRebootFactory SettingManual Gain Control*AGC Level Control*Uplink Tracking OffsetPeriodic TimeDate & TimeRSSI*Input Overload*Figure 12 - Variable Parameters in the Epoch-M1C Software
/ 38
This manual is suitable for:
Epoch-M1C series
Product
Menu
Learn More
Menu
Legal
Menu
Copyright © 2024 OneStart. All Rights Reserved