Advance acoustic Condor 4030C Instructions For Use & Warranty

Contents

Advance acoustic Condor 4030C Instructions For Use & Warranty Manual pdf 24 page image

A-24 / ENGLISHA-24 - FORM NO. 56041986 - Condor™SIDE BROOM MAINTENANCEThe side broom(s) move dirt and debris away from walls or curbs and into the path of the main broom. Adjust the side broom so that the bristles are contacting thefloor from the 10 O’clock (AA) to the 3 O’clock (BB) area shown in Figure 13 when the broom is down and running.The side brooms are adjusted through the adjust mode. To enter the “Adjust Mode” perform the following steps...1 Turn the Key Switch (A) to the OFF position (O).2 Press and hold the Side Broom Switch (C) and the Scrub Off Switch (E).3 While holding the switches (C & E), turn the key switch to the ON position (I).4 Continue to hold the switches for 2 seconds until side broom, scrub off and scrub on LED’s turn on.5 Release the switches. The Display (K) will now show “SIDE BROOM ADJUSTMENT”.Once inside of the “Adjust Mode” perform the following steps to adjust the side broom...1 Press Scrub On Switch (D) to lower the side brooms and press the Side Broom Switch (C) to raise the side brooms until the desired height is reached.2 To save the side broom height position, press the Scrub Off Switch (E). The side brooms will raise to the up position and the display will show a key icon(indicating that the key switch should be cycled off and on).3 The machine has now been reprogrammed to use the new side broom height position.NOTE: The machine should be stored with the Side Brooms in the raised position. The Side Brooms should be replaced when the bristles are worn to a length of3 inches (7.62 cm) or they become ineffective.To replace the Side Broom...1 Raise the Side Broom(s).2 Remove the large Pin (CC) holding the side broom on and remove the broom.3 Install the new broom by sliding it UP onto the shaft and re-installing the Pin (CC).FIGURE 13