When using FAN control, turn slowly allowingunit to adjust.When using THERMOSTAT, be sure to allowthree minutes before changing temperature.Adjusting too quickly may cause an overloadresulting in a blown fuse.CAUTION! !MODEThe mode knob controls fan speeds and coolingspeeds. To set desired cooling temperature, simplyrotate the mode knob dial to the appropriatesetting.LOW FAN will circulate the air at a minimum speedwithout cooling.MED FAN will circulate the air at a middle speedwithout cooling.HIGH FAN will circulate the air at a maximum speedwithout cooling.LOW COOL provides cooling, automatically withminimum air circulation. Recommended for night-time use.MED COOL provides cooling, automatically withmiddle air circulation. Recommended for night-time use.HIGH COOL provides cooling, automatically withquick cooling or for extremely hot days. Once roomis cooled, reduce setting to LOW COOL.NOTE: After setting the mode, allow 3minutes before switching to another mode.OFF will completely shut-off the unit.THERMOSTATThe thermostat automatically controls the coolingcycle (compressor) of the air conditioner to maintainroom temperature. However, the fan motor willcontinue to operate after the compressor (coolingcycle) is completed.Fresh Air Ventilation is usually kept in the closedposition. Use only when clearing smoke and/orodors from the room. Pull to open.p gFig. 15Mechanical control modelThermostatknobMode knobFig. 16Fresh AirVent LeverFHRFANSPEEDMODE OFFON/TIMERAirconditionerWAIT THREE MINUTESBEFORE RESTARTINGLOWFANMEDFANHIGHFANOFFHIGHCOOLMEDCOOLLOWCOOL135 79COLERO1313OPERATING INSTRUCTIONS➤MECHANICAL CONTROL MODELWAC 8-24 USER MAN FINAL 3/2/05 12:13 PM Page 15