1. All wiring must comply with local and nationalelectrical codes and must be installed by alicensed electrician. Once you have anyquestions regarding the following instructions,contact a licensed electrician.2. Check available power supply and resolve anywiring problems BEFORE installing and operatingthis unit.3. For your safety and protection, this unit isgrounded through the power cord whenplugged into a matching wall outlet. If you arenot sure whether your wall outlet is properlygrounded, please consult a licensedelectrician.4. The wall outlet(3-pin) must match the plug(3-pin) on the power cord supplied with the unit.DO NOT use plug adapters or extension cords.See (Table 1) for receptacle and fuse information.5. The rating plate on the unit contains electricaland other technical data. The rating plate is locatedon the right side of the unit.If the air conditioner has a serial plate ratingof 115 volts and up to and including 7.5 ampsthe unit maybe on a fuse or circuit breakerwith other devices. However, the maximumamps of all devices on that fuse or circuitbreaker can not exceed the amps of the fuseof circuit breaker.If the air conditioner has a serial plate ratingof 115 volts and greater than 7.5 amps itmust have its own fuse or circuit breaker,and no other device or unit should beoperated on the fuse or circuit breaker.To avoid the possibility of personal injury,disconnect the power to the unit beforeinstalling or servicing.Electric Shock Hazard1255K 6K 8KTable 11515RATED VOLTSCOOLING CAPACITYAMPSFUSE SIZEWALL OUTLETRECEPTACLE AND FUSE TYPES!Time Delay Fuse(or circuit breaker) Plug typeNote: 5K including AAW-05CR1FHU AAW-05CM1FHU6K including AAW-06CR1FHU AAW-06CM1FHU8K including AAW-08CR1FHU AAW-08DR1FHUAAW-08CM1FHU AAW-08DM1FHU6ELECTRICAL SPECIFICATIONSWAC 5 6 8 USER MAN final 3/2/05 12:23 PM Page 8