Addonics Technologies AEPUDDU User Manual

Contents

driver installation

Addonics Technologies AEPUDDU User Manual Manual pdf 3 page image

www.addonics.com Technical Support (M-F 8:30am - 6:00pm PST) Phone: 408-453-6212 Email: www.addonics.com/support/query/Driver InstallationFor Win98 and Win98SENote: Plug and Play under Windows Me, 2000 and XPUses Mass Storage Driver under Windows Me,Windows 2000 and XP (Plug and Play)1. Make sure your computer is up and running2. Verify that all cables are connected.3. Insert the Flash card that you will be using to the Digidrive.4. Connect the USB cable to the USB Port.5. A "New Hardware Found" message shall pops up.a. Follow the ON SCREEN wizard and point to the location of A:\USBWIN98 for thedriver.b. Let Windows finish the installation and that’s it.c. Double click My Computer icon and see if you have an extra drive letter for thePocket Ultra Digidrive.You may now access the Pocket Ultra Digidrive.Operation of Pocket UDDThe pocket UDD is designed not to draw any power when there is no media inserted. So the LED light willremain off even the device is connected to the computer.Use the following procedures to add or remove the media from the Pocket UDD.1. Insert the media fully into the device, the LED light will turn green, indicating the media isproperly inserted inside and the device is now turned on. Your operating system will report newhardware detected and begin to install the device. This may take a few seconds before a newdrive icon appears in the My Computer folder. During this initialization, the LED light on thePocket UDD toggles between orange and green color; and will stay green once the computerrecognizes the media.2. Once the drive icon appears, the media is now ready and can be used like regular floppymedia.3. During the read / write operation, the LED light of the Pocket UDD will turn Red.4. To remove the media, click on the Safe Remove icon to stop the connection as shown below.Once the “you may now safely remove window” shows up, you can then remove the mediafrom the Pocket UDD by pushing on the eject button.Note: if you eject the media from the Pocket UDD without checking the Safe Remove icon, awarning message will appear from Windows 98SE, Me and 2000. This message is a reminderthat it is safer to use the Safe Remove icon when you remove the media to prevent possibledata loss in case you are in the middle of copying a file to and from the media. You can goahead and close this message.5. After the media is ejected from the Pocket UDD, the LED light will go off, indicating the mediais fully ejected from the device.6. Do not pull the media out of the device without using the eject button. This may crash thecomputer, as it does not realize the media has been manually removed from the device.

/ 4

Related manuals for Addonics Technologies AEPUDDSA