2-3Microsoft Windows NT InstallationCompleting a Fresh Windows NT 4.0 InstallationFrom CD-ROM1 Insert the Windows NT 4.0 CD into the CD-ROM drive.2 Start your system. Press the F6 key when you see the followingmessage: “Setup is inspecting your computer’s hardwareconfiguration...”If you do not see this message, your system may not be setupto boot from a CD-ROM. You will need to install from floppydisks. See Completing a Fresh Windows NT 4.0 Installation FromFloppy Disk on page 2-2.3 When prompted, press S to specify an additional device.4 Press Enter to select Others; insert the Ultra160 FamilyManager Set disk for Windows in your floppy disk drive.5 Using the arrow keys, select the following driver and pressEnter:Adaptec Ultra160 Family PCI SCSI Controller (NT4.0)6 To add other host adapters that are not part of the Ultra160Family, press S and repeat from Step 4 for each additionaladapter and insert the appropriate driver disk. The AdaptecUltra160 Family host adapters use the same driver; it is notnecessary to install the driver again.7 Press Enter to continue with the Windows NT operatingsystem setup. Follow the instructions on-screen and in theWindows NT documentation to complete the installation.
