Chapter 7: Installing the Driver and an Operating System ● 50Installing with SUSE LinuxTo install the ICP RAID controller driver while installing SUSE Linux:1 Insert the first SUSE Installation CD.2 Restart your computer.3 When the SUSE installation selection screen appears, choose the type of installation youwant, then press the F6 key to indicate the use of a driver disk. (If F6 is not shown on thescreen, you may have an older version of SUSE; press the Alt key instead.)4 When prompted, insert the driver disk, then press any key to continue.5 Follow the prompts to set up the environment you want.6 If you are installing other third-party devices, install them now. Otherwise, select Back.7 Complete the Linux installation, following the instructions included with your operatingsystem.8 Continue with Managing Your Storage Space on page 60.Installing with NetWareNote: You will need your NetWare Installation CD to complete this task.To install the driver when installing NetWare:1 Restart your computer, then install NetWare. (For instructions, refer to your NetWaredocumentation.)To be able to load additional drivers later, select Manual install mode during the first partof the installation.To load additional drivers:a Select Modify when the storage adapters are displayed.b Select Storage adapters, then press the Insert key to add an unlisted driver from thefloppy disk.2 When the Device Types screen appears, check the Storage adapters list and select Modifyto add another driver.3 Select Storage adapters, then press Enter.All recognized controllers are displayed.4 If AACRAID is detected, delete it.5 Press Insert to add another driver.The available drivers are displayed.6 Insert the driver floppy disk.7 Press the Insert key to scan the floppy disk drive.Once the driver is selected, the Parameter screen is displayed.
