Chapter 7: Installing the Driver and an Operating System ● 63Installing with UnixWareNote: You will need your UnixWare Installation CD to complete this task.To install the Adaptec RAID controller driver when installing UnixWare:1 Insert the UnixWare Installation CD.2 Restart your computer.3 Follow the on-screen instructions to begin the UnixWare installation.4 When prompted to load more HBA drivers, insert the driver disk, then select Yes. (To loadmore HBA drivers, repeat this step.)5 When all drivers have loaded, select No.6 Complete the UnixWare installation, following the instructions included with youroperating system.7 Continue with Managing Your Storage Space on page 72.Installing with SolarisNote: This task is not necessary if you are installing Solaris 10 Update 2 or later. Instead, youcan choose to install Solaris using the in-box driver and update it either during or after theinstallation is complete, if required.Note: For systems without a floppy drive, you can create a driver disk by burning a CD with theaac_solaris-x86.iso file, available on the RAID Controller Installation DVD.To install the Adaptec RAID controller driver while installing Solaris:1 Start your computer.2 Interrupt the autoboot, press the ESC key. The Device Configuration Assistant (DCA)Utility will open.3 Select Apply driver updates.4 Insert the driver floppy disk or other update media, then press Return.5 Complete the Solaris installation, following the instructions included with your operatingsystem.Installing with VMwareNote: You will need your VMware Installation CD and a writable CD to complete this task. Youmust have root privileges to create the driver disk and install the driver image.To install the Adaptec RAID controller driver when installing VMware:1 Create the driver disk:a Insert and mount the RAID Controller Installation DVD:mount /dev/cdrom /mnt/cdrom
