Menu
Adapt4 XG1 Installation Manual
Also see for XG1: Installation manual
                           | |
Adapt4, Inc.1.3.1 Network Configuration Panel1. Set the Network ID and Radio Function fields:• Enter the Network ID in decimal or hexadecimal (beginning with “0x”). For example:25238 (decimal) or 0x6296 (hexadecimal). These two example values are equivalent(refer to the same network).• Click the Network ID checkbox (if it is not already checked).• Select a radio type by clicking the appropriate option (Factory Default, Hub, Remote,Mobile, or Digipeat) in the Radio Function area.• Click the Radio Function checkbox (if it is not already checked).• Click the Send Config to Radio button.2. Set the Installation StatusWhen the Field Installer has completed all steps and the field installation is complete, returnto this tab and set the installation status of the radio via the Installation Status field. TheField Installer indicates that the radio is installed and ready for further configuration from theEMS (which might not happen until after the Field Installer has left the site) by setting theInstallation Status field to the Installed value.• Deselect the Network ID and Radio Function checkboxes by clicking them.• Click the Installed radio button in the Installation Status area.• Click the Send Config to Radio button.• Click the Set Install Time/Date button to record the installation's time and date.Note: The EMS operator will set the Installation Status field to Commissioned (over-the-air) after the EMS has further configured the radio - possibly after the Installer has left thelocation.The present values stored in the radio can be retrieved by selecting all the checkboxes (orclicking the Check/Uncheck All checkbox) and clicking the Get Values from Radio button.1.3.2 Network Status PanelUse this panel to determine if the radio has joined the network. (This can happen before beingconfigured by the EMS; however, user traffic will not pass over the network until the EMSconfigures the site.) Click the Get Values from Radio button in this panel The network statuswill be displayed, including:• Run Status: If Run Status is in the joined state, the radio has connected with the network• Preamble Channel (changes frequently)• Number of Channels (1-45)• FEC Coding Rate (none, 1/2, 3/4 or 7/8)• Tx Power Level (changes frequently)• Last SNR (signal/noise ratio, which changes frequently)1.3.3 Antenna Pointing Tool PanelClick the Start button to start the tool. The tool will begin periodically polling the attachedremote radio for its signal strength from the Base Station. The tool will show the relative strength |
Related manuals for Adapt4 XG1
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved